Washer Lid Lock Not Working

It s not uncommon for a washer to develop a musty or mildew smell.

Washer lid lock not working.

Depending on your model some washers may fill without the lid locking and others will not even start until the lid locks. However some washing machines come with a lid lock. If the door lock is defective the washer door will not latch properly. If the control lock light is on hold the control lock button for three seconds to unlock the control.

Most washing machines come equipped with a lid switch. If your washer has an electronic touchpad tap the text not the lights to operate. Check your owner s manual for information on your specific model. This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve.

Pausing the wash cycle is how it can be disabled. The 2 front legs have a leveling mechanism with a lock nut to secure it in place. This switch performs the same function but the lid must be locked in place for the machine to wash. If the door lock is damaged or does not latch properly replace it.

Once the washer door is closed the washer can begin operating. The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress. If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor. The lid will lock and the machine will enter a pump out mode for 8 minutes.

Once the washer door is closed the washer can begin operating. If the door lock is defective the washer door will not latch properly. Washing machines are designed to stop working when the lid is open. Adjust each leg to the correct height and tighten the lock to keep the leg from moving.

To avoid making more work for yourself leave both of these attachments as they are. The lid must be completely closed and latched for the washer to operate. To determine if the door lock has failed. The lid lock switch assembly will still be connected to its wire harness which is usually secured to the underside of the washer s top panel via a series of clips.

This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is down. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the lid will not lock and keeps clicking on your whirlpool cabrio washer it is probably a faulty lock switch assembly.

If the door lock is damaged or does not latch properly replace it. Inspect the door lock for damage.