Water Softener Regeneration Steps

This step takes about 10 minutes.

Water softener regeneration steps.

Backwash 10 minutes this step removed accumulated dirt and such while also fluffing up the media bed. These devices work by either using a clock or by monitoring the amount of water used demand initiated regeneration softeners to tell the water softener when it is necessary to shut down and regenerate. A strong salt water brine solution is created with the salt added to the softener. To improve efficiency and extend the life of your water systems scale causing calcium and magnesium ions are replaced with sodium ions in the softening process.

The brine solution flows through the resin tank rinsing the beads and exchanging new sodium for the hard water minerals that have collected. Water softener regeneration is the process which the softener system removes the existence of calcium and magnesium as well as other minerals and dirt from the water. Remove the lid and refill your water softener s salt hopper with softener salt then close. The following steps are involved with regeneration.

The regeneration process starts with a backwash during which the softener pumps water backward through the treatment medium to remove sediment. To regenerate a softener that has reached capacity you must conduct four steps. The majority of home water softeners are equipped with automatic regeneration devices. Water softeners regenerate by removing trapped contaminants and replacing them with either sodium or potassium depending on which chemical you put in the brine tank.

The softener then goes back into what we call service position and the owner enjoys another 1 200 gallons plus or minus of soft water. Backwash brine draw slow rinse and fast rinse. Here are the typical water softener regeneration steps.